Sökresultat

Filtyp

Din sökning på "*" gav 550362 sökträffar

Study of a heavy duty Euro5 EGR-engine sensitivity to fuel change with emphasis on combustion and emission formation

A diesel engine developed for an international market must be able to run on different fuels considering the diesel fuel qualities and the increasing selection of biofuels in the world. This leads to the question of how different fuels perform relative to a standard diesel fuel when not changing the hardware settings. In this study five fuels (Japanese diesel, MK3, EN590 with 10% RME, EN590 with 3

HCCI combustion of natural gas and hydrogen enriched natural gas combustion control by early direct injection of diesel oil and RME

Natural gas and hydrogen enriched natural gas has been tested as fuels together with diesel oil and RME in a single cylinder Scania research engine. The gas was introduced as port injection while the diesel was introduced as early direct injection. Because the gas was premixed with air before combustion and the diesel was injected early in the compression stroke, the engine ran close to HCCI mode.

Improving ion current feedback for HCCI engine control

In HCCI you do not have the same control of the combustion like in SI and Diesel engines. Controlling the start of a combustion event is a difficult task and requires feedback from previous cycles. This feedback can be retrieved from ion current measurements. By applying a voltage over the spark gap, ions will lead a current and a signal that represents the combustion in the cylinder will be retri

Low power piezoelectric micro mass flow controller for liquid fuel injection

Utilization of an ethanol driven, combustion-based power generator promises high-efficiency combustion in diesel-like engines and avoids problems connected to shrinking supplies of fossil fuels since fuels like ethanol or dimethyl ether can be produced from renewable resources. Fuel injection into such generator through a piezoelectric micro mass flow controller (MMFC) features low power consumpti

Micro mass flow controller for a mini-HCCI-motor driven power generator

A piezoelectric micro mass flow controller (MMFC) for liquid fuel injection into a mini-HCCI-motor for power generation is introduced. Piezoelectric actuation ensures negligible power consumption for fuel injection allowing self-sustaining operation. A pressurized fuel tank is connected to the MMFC which is designed like a normally-closed, on-/off-operating valve. Integrated piezoresistors are use

Multi-Output Control of a Heavy Duty HCCI Engine Using Variable Valve Actuation and Model Predictive Control

Autoignition of a homogeneous mixture is very sensitive to operating conditions, therefore fast control is necessary for reliable operation. There exists several means to control the combustion phasing of an Homogeneous Charge Compression Ignition (HCCI) engine, but most of the presented controlled HCCI result has been performed with single-input single-output controllers. In order to fully operat

Revenue Nodes in South India and Central Java

Studies of relations binding ruled and ruler over the form and content of revenue assessment during the colonial era are not lacking. Rather, the intellectual challenge lies in ascertaining the degree to which the relevant economic institutions of the subjected regions in southern Asia constituted continuity of tradition, modifications thereof, or completely alien constructs. Meeting that challeng

Pressure oscillations during rapid HCCI combustion

This work has focused on studying the in-cylinder pressure fluctuations caused by rapid HCCI combustion and determine what they consist of. Inhomogeneous autoignition sets up pressure waves traversing the combustion chamber. These pressure waves induce high gas velocities which causes increased heat transfer to the walls or in worst case engine damage. In order to study the pressure fluctuations a

Epistemic Attitudes and Source Critique in Qualitative Research

In this essay, we explore and discuss current practices of source critique. In our empirical analysis of a sample of interview-based studies, we find that few studies show a careful and reflective stance toward their sources. In the majority of cases, we discern a tendency to either ignore basic issues of the trustworthiness of interview material or produce technical descriptions which seem to hav

Intergenerational Transmission of Human Capital : Is it a One-Way Street?

Studies on the intergenerational transmission of human capital usually assume a one-way spillover from parents to children. However, children may also affect their parents’ human capital. Using exogenous variation in education, arising from a Swedish compulsory schooling reform in the 1950s and 1960s, we address this question by studying the causal effect of children's schooling on their parents’

In-cylinder measurement for engine cold-start control

We examine the use of in-cylinder measurements for engine control, with emphasis on emissions control during cold start. First, the cold start emissions control problem is described. An overview of previous research in the area of in-cylinder measurements for control is presented, including sensors for pressure and other quantities. Next, analysis of cylinder pressure is described. Lastly, a cold-

Hybrid control of a manufacturing transport system

This paper describes the design of a least restrictive, safe hybrid control scheme for a manufacturing transport system transporting fragile objects from a production unit to a stamping/packaging station. The control scheme consists of several control modes. One control mode handles trajectory following using time-optimal control, the other control modes are safety related and are engaged in a lea

International Import Competition and the Decision to Migrate : Evidence from Mexico

We analyze the effects of the increase in China’s import competition on Mexican domestic and international migration. We exploit the variation in exposure to competition from China, following its accession to the WTO in 2001, across Mexican municipalities and estimate the effect of international competition on the individual decision to migrate. Controlling for individual and municipality features

Polynomial Reconstruction of 3D sampled Curves Using Auxiliary Surface Data

This paper proposes a method for structural enhancement of a 3D sampled curve. The curve is assumed to be organized, but corrupted with low frequency noise. The proposed method approaches the notion of curve reconstruction in a novel way, where information about the structure in a scanned surface is used to reconstruct the curve. Principal Component Analysis is carried out on successive neighborho

‘A forest of urbanization’: Camp Metropolis in the edge areas

This article examines two issues located at the core of thePalestinian struggle: Jerusalem and the refugee camps. I aim totrace the forced encounter staged at these two crucial sites ofcontestation, while looking at the collisions/interactions that occurbetween them, and the types of geographies that are producedwithin an experience of abandonment. This is done by exploringhow the colonized re-pro

Shifting realities: dislocating Palestinian Jerusalemites from the capital to the edge

Lefebvre’s ‘right to the city’ was an expression of a new politics of citizenship,residency and above all the right to urban life. We thus build our argument inthis paper on the Lefebvre concept and through the case study of Kufr Aqab, thenorthernmost neighbourhood of the occupied city of Jerusalem. In order tosystematically displace Palestinian Jerusalemites and to achieve the Judaisationof Jerus