An inventory and analysis of extinguishing agents and systems. A quantitative analysis of the weight of the systems and of the damage on hull material for different fire scenarios. Tests have been carried out in cone calorimeter and simulations in HSLAB and FREIA:

A probabilistic riskanalysis of a railway tunnel in Örnsköldsvik, Sweden. Using societal risk showing the hazard of the system. The analysis indicates a high risk greater than recommended levels of acceptance according to international risk criteria. Furthermore proposal for hazard prevention in tunnels are made.

The purpose of this study is to evaluate the safety of people located in discotheques in case of fire. A quantitative fire riskanalysis (QRA) for three different types of discotheques is carried out. The analysis is based on performance based codes from which fire protection alternatives are analysed. The results of the quantitative fire riskanalysis are described as risk profiles and average risk

A serie of ten full scale fire scenerios has been analysed in a compartment with and without residentiual sprinkler. The production of carbon monoxide, carbon dioxide and oxygen was measered in two different heights in the compartment during the tests. (Swedish)

A waterflow measurement device has been developed with which it will be possible to simultaeously study both amount of water applied and its effect temperature, during firefighting in an firetraining house. Major part of the applied water is used to cool the surface of the non-flaming fuel. Short showers with the nozzle does not seem to be as effective as the longer showers, regarding both time to

Evaluation of fire fighting spray nozzles when cooling hot smoke gases in a compartment fire. Computer simulations have been made concerning the fire scenario and time to reach fire control when water is applied. Total amounts of water are also calculated. Suggestions and conclusions drawn from the results are shown in the report. (Swedish)

In this report the cutting extinguisher is evaluated based on the cutting ability of carbon fibre laminate boards and the fire extinguishing ability. Laboratory tests and full scale tests have been carried out. Results from the tests, computer simulations and theories are discussed and compared. Suggestions and demands on improvement are presented.

Small overview of the computer based evacuation models Allsafe, Evacnet, Simulex, Steps and Wayout, focusing on their ability to predict evacuation time, based on comparison between full-scale evacuation experiment and simulation results. Diagrams showing processes of evacuation and deviations illustrate comparison results.

The aim of this report is to evaluate the evacuation situation for locomotion disabled people. The methods that have been used are literature research, interviews, questionnaires and experiments. Experiments are performed to measure factors that influence the egress for locomotion disabled people.

Analyses with Point Scheme Risk Analysis method for hospital wards and event tree analysis at several ward at homes for the aged in order to evaluate the agreement between the two methods.

The purpose of the report is to evaluate pilot safety in combat aircraft’s, of type JA 37 Viggen and type JAS 39 Gripen, exposed to the worst scenario of fire. Focus is on the performance of the canopy of the cockpit. The method used involves small-scale laboratory tests as well as a full-scale test with a Viggen in a pool fire. The conclusion is that the pilot in a Viggen has to be evacuated with

This report investigates problems concerning the use of clean agents in a low-temperature environment, i. e. temperatures below the boiling-point of the agent. Three commercially available agents have been included in the tests: HFC-227ea, HFC-236fa and FS49C2. The results from the tests show that the use of an agent should be avoided at temperatures below its boiling point, although some fire-e

The risk of smoke and fire spread for three ventilation system in an office building in Stockholm has been analyzed. The building was built in 1994 in accordance with former regulations. The analyzes are made performance based with computer simulations. The following ventilationsystems are analyzed: elevator shaft, office, rooms for technical support. The system serving office fulfills the regulat

The aim of this project was to develop a model that can be used during fire inspections to measure the quality of the fire safety in a building. The model was created by using method for Multiple Attribute Decision Making (MADM). Ten factors were identified, each of them contributing to the total fire safety in a building. Each factor was given a weight to specifiy its importance to the fire safet

A detailed flammability evaluation of different materials used in the nuclear power industry is presented as an example of how important are physical observation and detailed analysis in the interpretation of test data. The objective is to provide different criteria that could allow the use of standard test data in fire modeling. So far most fire test data has only been used as an element for rank

This report performs a risk analysis of AB Elektrokoppar in Helsingborg with consequence analysis of a few hazards. Theoretical background about risk analysis is given by IEC standards.

This report is an attempt to make a modern Rescue Services Plan that can be used in the education at the Swedish Rescue Service Agency in Rosersberg. The plan will be only temporary because of the ongoing reformation of the Rescue Services Act. A modern plan should contain activities controlled by objectives aiming at improving the safety in the society. The plan is based on the term Protection Ag

A proposal of how the pre-planning process for the attack/contingency plans can be done with the purpose to achieve an effective collaboration between the fire department and the proprietor/building owner.

The purpose of this report is to evaluate spontaneous combustion of two vegetable binders, linseed oil and tung oil. Binders with driers are common in sheet-fed offset inks. The methods used are literature research and experimental studies. The experimental study is divided in two parts, experiments in a preheated cupeling furnace, and experiments with differential scanning calorimetry-apparatus.